Fastening the Power Tool
Fastening the Power Tool on the Mounting Plates (see figure A)
The mounting plates (4) are suitable for general use. The various different mounting holes allow the following power tools from Bosch to be mounted on the saw stand.
|
Model |
Mounting plate L |
Mounting plate R |
|---|---|---|
|
GTS 70-216 |
J |
Y |
GTS 10 J | J | J |
GTS 635-216 | T | T |
- Position the power tool in the centre over the corresponding mounting holes.
- Screw together the mounting plate and power tool using the compatible screws, washers and nuts.
GTS 70-216, GTS 18V-70: The screw is guided from below through the mounting plates. The nut sits on top of the power tool frame.
Fastening the Power Tool on the Assembly Rod (see figure B)
The assembly rod (3) is suitable for general use. The various different mounting holes allow the following power tools from Bosch to be mounted on the saw stand.
Model | Mounting holes |
|---|---|
GTS 10 XC | A |
GTS100-254 | B |
- Position the power tool in the centre over the corresponding mounting holes.
- Screw together the assembly rod and power tool using the compatible screws, washers and nuts.
When doing so, the screw is guided from above through the power tool frame. The nut sits on the bottom of the assembly rod frame.