Fitting the Mounting Plates (see figure i)
Fastening set C
- Place the mounting plates (4) on the assembly rod (3).
L: Direction of the cross bar (8)
R: Direction of the handle (1)
Depending on the model, the elongated holes (H, G) in the mounting plates must be flush with different assembly holes (A, B) in the assembly rod.
|
Model |
Mounting plate L |
Mounting plate R |
|---|---|---|
|
GTS 70-216 |
Assembly hole B |
Assembly hole B |
GTS 635-216 | Assembly hole B | Assembly hole A |
- Screw the elements together as far left as is possible in the elongated hole (direction of the cross bar).