Assembling the Saw Stand

Carefully remove all parts included in the delivery from their packaging.
Remove all packing material.
For assembly, follow figures a−h.

Fastening set A

Screw together a wheel (2) to each lower frame (5).
Turn the wheel. If the wheel cannot be turned freely, release the nut by a 1/8 to a 1/4 turn.

Fastening set B

Screw both the left-hand and right-hand linkage bars (6) onto the lower frame (5)
Use the welded sockets for this purpose.

Note: The locking bolt (12) is located on the right-hand linkage bar (6).

Fastening set C

Insert the left-hand linkage bar (6) into the left-hand support rod (7) until they are aligned with the assembly holes.
Screw both elements together.
Repeat the steps with the right-hand linkage bar (6) and the right-hand support rod (7).

Fastening set D

Insert the cross bar (8) onto the left-hand and right-hand support rods (7) until they are flush with the assembly holes.
Screw the elements together.

Fastening set C

Insert the handle (1) into the left-hand and right-hand support rods (6) until they are flush with the assembly holes.
Screw the elements together.
Screw the rubber threaded caps onto the protruding screw threads to protect your hands against injury in the handle section.

Fastening set E

Screw together the upper frame (9) and the lower frame (5).
Tighten the screw connection firmly. Then loosen the nut by a 1/8 or a 1/4 turn.
Note: To ensure that the screw connection is not tightened too firmly, it must be possible to freely rotate the centre washer.

Fastening set F

Screw together the upper frame (9) and the assembly rod (3).
Tighten the screw connection firmly. Then loosen the nut by a 1/8 or a 1/4 turn.
Note: To ensure that the screw connection is not tightened too firmly, it must be possible to freely rotate the centre washer.

Fastening set E

Screw the assembly rod (3) onto the left-hand and right-hand linkage bar (6).
Tighten the screw connection firmly. Then loosen the nut by a 1/8 or a 1/4 turn.
Note: To ensure that the screw connection is not tightened too firmly, it must be possible to freely rotate the centre washer.
Screw the rubber threaded caps onto the screw threads to protect your hands against injury in the handle section.