Fitting Extractor Accessories (see figures C and G)

The vacuum hose (15) is fitted with a clip system that can be used to connect the extractor accessories (combi power tool adapter (17), curved nozzle (18)).

  • Push the curved nozzle (18) onto the vacuum hose (15) until you hear both snap fasteners (16) on the vacuum hose engage.
  • To remove the adapter, press the snap fasteners (16) inwards and pull apart the components.

  • If required, place the suction tubes (19) firmly inside one another and then attach them firmly to the curved nozzle (18).
  • Attach the floor nozzle (21) or the crevice nozzle (20) firmly to the suction tube (19) or the curved nozzle (18).

The combi power tool adapter (17) consists of the PowerTool adapter (front part) (24) and the PowerTool adapter (rear part) (25).

Figure G shows the possible diameters of extraction nozzles that can be connected to the combi power tool adapter (17).

If necessary, place the PowerTool adapter (front part) (24) on the PowerTool adapter (rear part) (25) and lock it in place by turning it anticlockwise.

Depending on the required connection diameter, only fit the PowerTool adapter (rear part) (25) or the assembled combi power tool adapter (17) on the vacuum hose. Allow the two push buttons (16) of the vacuum hose in the PowerTool adapter (rear part) (25) to audibly click into place.

To separate the two adapter parts, turn the PowerTool adapter (front part) (24) clockwise and remove it.

To remove the combi power tool adapter (17) from the vacuum hose, push the push buttons (16) inwards and pull the combi power tool adapter out of the vacuum hose.